Vision Controls Cam SS Version 5.01 Manuel d'instructions télécharger pdf (Page 16)

15 / 69

http://www.toshiba-teli.co.jp/index.htm

D4211908A

Connection

● In the case of supply DC+12V to the camera.

● In the case of supply PoE power to the camera.

Notes on Connection:

- Please confirm the power supply of the camera off when plugging in or pulling out the I/O Connector. It causes the

breakdown.

- If your camera is used in a system where its connectors are subjected to strong repetitive shocks, its connectors are

possible to break down. If you use your camera in such a situation, use an LAN cable with a lock screw, and secure

the camera cable as close as possible to the camera body for avoid physical shock to the camera connector.

- About Camera cable: In the case that electric-wire is long or thin, input voltage may not satisfy specifications of the

power supply voltage of the camera by voltage drop. Please confirm it before use.

Lost packets may occur by an electrical characteristic of the transmission line of using Ethernet devices (LAN cable,

Network Interface Card, Switching HUB).

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 70 71

Pas de commentaire

Vision Controls Cam SS Version 5.01 Manuel d'instructions Page 16